Technology Insights

Linksys WRT600N Running DD-WRT Wireless Devices Not Communicating With Wired Devices

If you are having trouble communicating between the wired and wireless networks after installing or upgrading your Linksys WRT600N wireless router with dd-wrt firmware then the issue is likely related to the VLAN configuration. After you flash the firmware on a Linksys WRT600N you will have the default dd-wrt settings. One of these settings includes separating the wired and wireless traffic because this is the correct way to secure things because the wireless network is much more likely to be breached than the wired network. Switching this setting to allow communication between wired and wireless devices is easy by following the directions below.

  1. Login To WRT600N: Visit the web administration GUI at your routers internal IP address using the HTTPS protocol. If HTTPS is not set up then you should first configure that before you proceed.

Technology Insights

Configure Static IP and DNS on HP Photosmart C5150

The easiest way to configure a static IP on the HP Photosmart C5100 is via the web interface. You probably do not know to the IP address of the all-in-one printer since you are just now configuring the static IP and if it is currently on the netork then it has received a dynamic IP address via DHCP (Dynamic Host Configuration Protocol). Regardless its an easy process which I will explain step by step below.

  1. Locate IP Address: First we will need to locate the current Internet Protocol address of the printer. Look in the properties of the printer and look at the Ports tab to see if there is an IP address specified. If there is not then you can print a test page, bring up a command prompt, and type “arp -a”. You should notice a couple different IP addresses of which one should be associated with a Physical Address that begins with 00:19:BB which is Hewlett Packard. Once you have located the IP address take note. It should be an address where the first three octets begin with 192.168.0.