belkin wemo light bulbs and wemo switch

WEMO Application Not Detecting LED Bulbs

When I first purchased the Belkin LED Lighting Starter Kit I didn’t have any issues getting the two A19 LED bulbs working with the Belkin WEMO Link Controller. I recently moved and had all sorts of problems getting the WEMO iPhone application to not only configure the WEMO Link Controller but once configured I could not figure out how to get the WEMO iPhone application to see either of the A19 LED bulbs. If I had known the proper steps to reset everything it would have been a snap so I wanted to share resetting everything back to factory defaults including the WEMO Link Controller and the WEMO A19 LED Bulbs. Follow the steps below to set all of the WEMO devices back┬áto factory default and configure the WEMO iPhone application from scratch.

Technology Insights

Linksys WRT 600N Wireless Router Upgraded With DD-WRT Firmware Issues

I have been running dd-wrt firmware on my Linksys wrt600n for awhile now however I have always had some issues. I had finally had the configuration to where the issues were minimal however it has never been perfect. I decided since it had been a couple months it was time to try a newer build from the site. I upgraded and things got a lot worse in terms of wireless on the 2.4 GHz channel so I did a ton of troubleshooting and read a lot of posts semi related to my problems with the 600N on the dd-wrt forum. During the reading I learned a lot about the proper way to flash the firmware and I wanted to share my findings here.

First off when you upgrade the firmware you are supposed to do a hard reset before the firmware upgrade and after the firmware upgrade. A hard reset should be done following the below directions.

**NOTE** Hold the reset button in during this entire process