Posts Tagged “hard reset”

Sometimes it is necessary to hard reset a Plantronics Voyager 510 bluetooth headset if it stops responding to button presses or if you need to start pairing with another bluetooth device again. Below is an image describing the four buttons that can be pressed on the PLT-510 headset. These buttons can be pressed in various combinations to perform various tasks.

Read the rest of this entry »

DeliciousStumbleUponDiggTwitterFacebookRedditLinkedInEmail
Tags: , , , , , , ,

Comments 2 Comments »

I have been running dd-wrt firmware on my Linksys wrt600n for awhile now however I have always had some issues. I had finally had the configuration to where the issues were minimal however it has never been perfect. I decided since it had been a couple months it was time to try a newer build from the site. I upgraded and things got a lot worse in terms of wireless on the 2.4 GHz channel so I did a ton of troubleshooting and read a lot of posts semi related to my problems with the 600N on the dd-wrt forum. During the reading I learned a lot about the proper way to flash the firmware and I wanted to share my findings here.

First off when you upgrade the firmware you are supposed to do a hard reset before the firmware upgrade and after the firmware upgrade. A hard reset should be done following the below directions.

**NOTE** Hold the reset button in during this entire process

Read the rest of this entry »

DeliciousStumbleUponDiggTwitterFacebookRedditLinkedInEmail
Tags: , , , , , , , , ,

Comments 17 Comments »